Filter
Top Products
29
FEATURES AND CONTROLS
Electronic Reverse (PERCt) (600RR)
Disengaging Reverse
1. Stop the snowmobile and leave the engine idling.
2. Push the reverse button for one second and release. The engine will
slow and begin to rotate forward. The light on the tachometer will
shut off.
3. Apply the throttle slowly to make sure the transmission is in
forward.
Altitude Setting
At higher altitudes (above 6000 feet), the engine will require a different
ignition setting to improve the success of the reverse system. To set for
a higher altitude, start the engine and hold the button down until the
light on the tachometer flashes rapidly, then release the button.
To set the reverse for lower elevations, continue holding the button
down until the reverse indicator light blinks slowly. Once set, it’s
stored in memory until changed, whether the engine is running or not.
Reverse Kit Maintenance
If your snowmobile is equipped with reverse, or if you have a reverse
kit installed, it’s especially important to maintain track tension as
specified on page 88.
WARNING
Improper track tension can cause serious damage to the snowmobile,
which can result in loss of vehicle control and serious injury or death.
Always maintain the track tension as specified.