Polaris 600 Widetrak IQ Offroad Vehicle User Manual


 
67
OPERATION
Starting the Engine
1. Turn the key to the ON position.
NOTICE: Engaging the starter when the engine is running WILL result in serious
engine damage, especially if the transmission is in reverse. Never
engage the starter when the engine is running.
2. Pull the engine stop switch up to the RUN position.
3. If equipped with electric start, turn the key to START to crank the
engine. Release the key to the ON position when the engine starts.
4. If not equipped with electric start, grasp the starter handle and pull
slowly until the recoil engages; then pull abruptly to crank the
engine.
TIP:Don't pull the starter rope to the fully extended position and don't allow it to
snap back into the housing. Damage may result.
5. If the engine does not start after several attempts, slightly depress
the throttle (no more than 1/4I open) while cranking the engine.
When the engine starts, immediately release the throttle.
CAUTION! To avoid injury and/or engine damage, do not operate the electric
starter or pull-rope starter while the engine is running.
NOTICE: Operating the vehicle immediately after cold starting could cause
engine damage. Allow the engine to warm up for several minutes
before operating the vehicle. If cold drive-away is attempted, the
engine RPM may stumble slightly to protect the engine.