Polaris 600 Widetrak IQ Offroad Vehicle User Manual


 
110
MAINTENANCE
Battery
WARNING! Improperly connecting or disconnecting battery cables can result in
an explosion and cause serious injury or death. When removing the battery,
always disconnect the negative (black) cable first. When reinstalling the battery,
always connect the negative (black) cable last.
Battery Removal
1. Release the seat latch and raise the seat to access the battery.
2. Disconnect the black (negative) battery cable first.
3. Disconnect the red (positive) battery cable last.
4. Remove the battery.
Battery Installation
When installing a new battery, make sure it's fully charged prior to its
initial use. Using a new battery that has not been fully charged can dam-
age the battery and result in a shorter life. It can also hinder vehicle per-
formance. Follow the battery charging instructions on page 112 before
installing the battery.
1. Ensure that the battery is fully charged.
2. Set the battery in the battery holder.
3. Connect and tighten the red (positive) cable first.
4. Connect and tighten the black (negative) cable last.
5. Verify that cables are properly routed.
6. Lower the seat and secure the latch.