Filter
Top Products
113
MAINTENANCE
Camber and Caster
The camber and caster are non-adjustable.
Rear Spring
The rear shock absorber spring is adjusted
by rotating the cam either clockwise or
counter-clockwise to increase or decrease
spring tension.
Accessory springs are available through
your POLARIS dealer.
Handlebars
The handlebars can be adjusted for rider
preference.
WARNING! Improper adjustment of the
handlebars or incorrect torquing of the adjuster
block tightening bolts can cause limited steering
or loosening of the handlebars, resulting in loss
of control and serious injury or death. Follow the
adjustment procedures exactly, or see your
POLARIS dealer for service.
1. Remove the upper headlight
pod.
2. Loosen the four handlebar
bolts.
3. Adjust the handlebar to the
desired height.
4. Be sure the handlebars do not
contact the gas tank or any
other part of the machine when
turned fully to the left or right.
5. Torque the front two bolts to
10-12 ft. lbs. (14-17 Nm), then
torque the rear two bolts. A
gap of up to 1/8" (3 mm) will
remain at the rear of the clamp blocks.
High
Tension
Low
Tension
Cam
Handlebar
Bolts