Filter
Top Products
94
MAINTENANCE
Clutch System
n Drive Belt Deflection
Measure belt deflection with
both clutches at rest and in
their full neutral position.
Place a straight edge (1) on the
belt and apply downward pres-
sure while measuring at point
2. This measurement should be
1 1/4I (3.2 cm).
Drive Belt Adjustment
Belt deflection should be adjusted without removing the clutch from the
jackshaft.
1. Loosen the 7/16I jam nut on the belt width adjuster.
2. Using a 1/8I Allen wrench, adjust the threaded set screw as needed.
NOTE: Turn the set screw in (clockwise) to increase the distance
between the sheaves and out (counterclockwise) to decrease
the distance.
3. Tighten the jam nut.
1
2