Filter
Top Products
93
MAINTENANCE
Battery
Battery Installation
Using a new battery that has not been fully charged can damage the
battery and result in a shorter life. It can also hinder vehicle
performance. Follow the battery charging instructions on pages 95-97
before installing the battery.
1. Ensure that the battery is fully charged.
2. Place the battery in the battery holder.
3. With conventional batteries, install the battery vent tube (sealed
batteries do not have a vent tube).
NOTE: The vent tube must be free of obstructions and securely
installed. Route the tube away from the frame and vehicle
body to prevent contact with electrolyte.
WARNING
Battery gases could accumulate in an improperly installed vent
tube and cause an explosion, resulting in serious injury or death.
Always ensure that the vent tube is free of obstructions and is
securely installed as recommended.
4. On conventional batteries, coat the terminals with dielectric grease
or petroleum jelly.
5. Connect and tighten the red (positive) cable first.
6. Connect and tighten the black (negative) cable last.
7. Install the battery cover.
8. Secure the battery hold-down strap.
9. Verify that cables are properly routed.
NOTE: Cables should be safely tucked away at the front and rear of
the battery.