Filter
Top Products
29
After Installing this Product
1. Reconnecting the battery.
First, double-check that all connections are correct and that this product is installed cor-
rectly. Reassemble all vehicle components that you previously removed. Then reconnect
the negative (–) cable to the negative (–) terminal of the battery.
2. Start the engine.
3. Press the RESET button on the display unit.
Press the RESET button on the display unit using a pointed object such as the tip of a pen.
4. Enter the following settings:
1. Install the program in the navigation system.
2. Drive until the initialized sensors start operating normally.
3. Set the time and language.
Set the navigation system as explained in the Operation Manual or Hardware Manual.
After installing this product, be sure to check at a safe place that the vehicle is per-
forming normally.
Note:
If you reconnected the Hide-away unit, press the RESET button.
ENG/MASTER 96
<CRD4069A/U> 30
CRD4069-A_U_inst_001_031_US 10/25/05 10:58 Page 30