Filter
Top Products
DIN Front/Rear-mount
The display unit can be properly
installed either from “Front” (conven-
tional DIN Front-mount) or “Rear”
(DIN Rear-mount installation, using
threaded screw holes at the sides of the
unit chassis). For details, refer to the
following illustrated installation meth-
ods.
Before installing the display unit
• Remove the frame and the
holder.
To remove the frame, extend top and
bottom of the frame outwards in order
to unlock it.
Loosen the screws (2 × 3 mm) to
remove the holder. (When reattaching
the frame, point the side with a groove
downwards and attach it.)
• It becomes easy to remove the frame
if the front panel is released.
DIN Front-mount
Installation with the rubber bushing
1. Decide the position of the side
brackets.
When installing in a shallow space,
change the position of side brackets. In
this case, stick conceal tape on parts
that protrude from the dashboard.
2. Install the display unit into the
dashboard.
After inserting the holder into the
dashboard, select the appropriate tabs
according to the thickness of the dash-
board material and bend them.
(Install as firmly as possible using the
top and bottom tabs. To secure, bend
the tabs 90 degrees.)
• After installing the display unit into
the dashboard, reattach the frame.
• If you prefer an off-set installation
in which the front panel is pushed
further back, when there is a space
available at the back of the unit, use
AD-GA10 (sold separately).
Rubber bushing
Scre
w
Dashboard
Side bracket
Screw (2 × 3 mm)
182
53
Holder
Display unit
Conceal tape
Side bracket
Flush surface screw (5 × 6 mm)
Display unit
Holder
Frame
Screw (2 × 3 mm)
Display unit
24
ENG/MASTER 96
English
Español
Deutsch
Français
Italiano
Nederlands
<CRD4069A/U> 25
CRD4069-A_U_inst_001_031_US 10/25/05 10:58 Page 25