Filter
Top Products
Wire Routing Continued
4. Pass the Signal
®
mirror wire
harness into the mirror
mounting area and up
through the rubber
grommet. Remove any
slack.
5. Bolt the mirror housing on
the door using the three
mirror mounting nuts.
6. Reconnect the factory
mirror wire harness.
1997-2001 Honda CRV
2002-2003 Honda CRV
4
5
6
3
4
5
3. Remove the footrest on the
driver side floorboard by
removing the two bolts.
4. Remove the plastic
grommet in the upper right
corner of the plastic trim in
the corner of the door.
5. Dislodge the plastic
grommet from the center
of the plastic trim and
remove the trim from the
corner of the door. Route
the Signal
®
mirror wire
harness from inside the
rubber boot into the
vehicle.