Filter
Top Products
Using the shorter of the two wires from the kit,
starting from the inside of the mirror housing, guide
the end without the mating connector down
alongside the existing factory mirror harness.
Leave about 7 inches of wire exposed in the mirror
housing. Guide the wire harness through the mirror
bracket and remove any slack.
Replace the three screws and screw covers on the
bottom of the mirror bracket. Guide the wire harness
through the foam insulation and reposition the foam
insulation on the mirror bracket.
7
8
9
Lay the Signal
®
mirror on a clean, flat surface.
Connect the Signal
®
mirror mating connector to the
Signal
®
mirror wire harness.
Position the guides on the top of the Signal
®
mirror
into the slots on the top of the mirror mount. Tuck
the wire harness to the back of the mirror housing.
Pivot the Signal
®
mirror down on the mirror mount.
Firmly press down on the bottom edge of the Signal
®
mirror to snap it into position.
10 11 12
M
irror Replacement Continued
1997-2003 Honda CRV