Filter
Top Products
Axle Arm Removal
It is recommended that the axle is first removed from the dumper before the axle arm is
removed.
Drain the oil from the axle as described under section A, remove the halfshaft as
described previously.
Support the weight of the axle arm and remove the ring of bolts around the flange of the
arm. Place a drip tray below the axle arm and case to catch any oil which may run out.
Carefully withdraw the arm away from the centre housing taking care with the brake
plates, discs, sun gears etc. which are located between the axle arm and centre casing.
On refitting the arm ensure the mating surfces of the arm and centre housing are coated
with the recommended sealant. Align the arm with the centre casing, engage the sun
gear with the differential, ensure the dowels in the arm are aligned and refit the bolts.
Tighten the bolts to the correct torque.
Refit the halfshaft and top up the axle oil.