Filter
Top Products
Page - 32
Feature #6: Doors Lock At Ignition "On" (Factory Setting ON)
Feature Turned On: The security system will automatically lock the vehicle's
doors one second after the ignition switch is turned "on". This feature adds
considerable personal security to you and your family.
Feature #7: Doors Unlock At Ignition "Off" (Factory Setting ON)
This Feature will cause the security system to automatically unlock the vehicle's
doors instantly when the ignition switch is turned "off".
Feature #8: Not used on this model.
Feature #9: Open Door Bypass To Features #6, #7 (Factory Setting ON)
Feature Turned On: When the security system locks and unlocks the doors from
Features #6 or #7, if a door is open the doors will not automatically lock when the
ignition switch turns "on", or automatically unlock when the ignition switch is
turned "off".
Feature #10: Lights On 5 / 30 Seconds Upon Disarm
(Factory Setting 30 Seconds)
Feature Turned On: Upon disarming, the exterior and interior lights will stay on
for 30 seconds, to illuminate the way to your vehicle.
Feature Turned Off: The exterior and interior lights will stay on for 5 seconds
when the system is disarmed.
Feature #11: Automatic Rearming (Factory Setting ON)
Feature Turned On: When the transmitter has disarmed the security system, the
system will rearm and relock the doors 90 seconds later, unless a door is opened or
the ignition is turned on. This feature prevents the system from being accidentally
disarmed if a transmitter button is unknowingly pressed by an object while in a
pocket or purse, or from children playing with the transmitter.
Feature Turned Off: When the transmitter has disarmed the security system, the
system will stay disarmed until the transmitter is used to arm it again.
Feature #12: 2nd Channel Output Disarms System (Factory Setting ON)
Feature Turned On: When the 2nd channel output is utilized, the security system
will also disarm at the same time, chirping the siren twice, unlocking the doors and
turning the exterior lights on for thirty or five seconds. The 2nd channel output, and
this feature, can be used for remote trunk release operation.
Page - 33
Feature #13: .8 / 3 Second Doorlock Pulse (Factory Setting .8 (ON)
Feature Turned On: The doorlock outputs have a .8 second negative pulse to an
optional doorlock interface to operate the vehicle's power doorlocking system.
Feature Turned Off: The doorlock outputs have a 3 second negative pulse to an
optional doorlock interface to operate the vehicle's vacuum doorlocking system.
Feature #14: Double Unlock Pulse (Factory Setting OFF)
Some newer vehicles require a doorlock interface which provides a double doorlock
output pulse to unlock all of the vehicle's doors. Feature #12 must be .8 second
doorlock pulse time (Feature #12 turned ON) for Feature #14 to operate.
Feature Turned On: The unlock output provides two pulses.
Feature Turned Off: The unlock output provides a single pulse.
Feature #15: 3 / 45 Second Arming Delay (Factory Setting 3 Seconds (ON)
Feature Turned On: The security system will be become fully armed 3 seconds
after the arming siren chirp confirmation.
Feature Turned Off: The security system will be become fully armed 45 seconds
after the arming siren chirp confirmation.
Note: During the arming delay if any protected circuit should go into a triggered
state, the system will arm, but that circuit will be unprotected until it reverts back
to an non-triggered state.
Page - 34
Feature #16: Confirmation Chirp (Factory Setting ON)
Feature Turned On: The security system will chirp the siren for confirmation that
the system armed and disarmed.
Feature Turned "Off": The security system will
not have siren chirps for the
arming and disarming confirmation. Turning this feature off will also eliminate the
three chirps upon arming if the instant trigger circuit is grounded, and the four chirps
upon disarming if the system was triggered and reset. However, the Prewarn Feature
and the Programmable Features chirps will still operate.
Regardless of this Feature, eliminating the siren chirp may be done on a onetime
temporary basis as desired by pressing the small left transmitter button twice for
arming or disarming. Even if this Feature is used to remove the confirmation chirps,
the audible Automatic Transmitter Verification
TM
feature will still operate.
Feature #17: 30 / 60 Second Activated Alarm Cycle
(Factory Setting 60 Seconds (ON)
Feature Turned On: Upon activation, the siren will sound and the parking lights
will flash for 60 seconds.
Feature Turned Off: Upon activation, the siren will sound and the parking lights
will flash for 30 seconds.
Please note that the shorter 30 second activated time may be required in some
localities to comply with noise nuisance ordinances.
Page - 35