Filter
Top Products
Get started
10
Connect the DC-3 charger to the charger connector on the navigation
device, and insert the charger plug into the cigarette lighter socket of
your car. Power must be supplied by the 9- to 18-volt car battery. Ensure
that the charger is properly inserted in the cigarette lighter socket and
does not interfere with the normal operation of the car.
In some car models, the cigarette lighter socket is powered by the car
battery even when you remove the ignition key. In those cases, the car
battery might be discharged if the navigation device is left on, or if the
device is turned off but connected to the cigarette lighter socket for a
long time. Contact the vehicle manufacturer for more information.
When you charge the battery, the yellow indicator light flashes. If
charging does not start, disconnect the charger, plug it in again, and retry.
When the battery is fully charged, the indicator light turns off.
Once the battery is fully charged, disconnect the charger from the
navigation device and the cigarette lighter socket.
When battery power is low, the red indicator light flashes and the battery
icon at the top of the application menu screen shows no green bars.
You can use the navigation device while it is connected to the cigarette
lighter socket.
■ Install the device in a car
To use the navigation device in a car, attach the mounting device HH-14
to the windshield, attach the mobile holder CR-79 to the mounting
device, attach the navigation device into the mobile holder, and connect
the navigation device into the cigarette lighter socket of your car.
9200268_EN_SP_POB_FR.book Page 10 Friday, March 9, 2007 12:52 PM