Filter
Top Products
18 ‘04-’05 Nissan Titan - Kit 40053
b. Install kit bracket, straight on the wheel well
side of the fuel / brake line bracket with a kit
washer (1/4” SAE) and kit nut (1/4” nylock) as
shown. Install two kit brackets and fuel / brake
line bracket on firewall with two nuts.
Engine Compartment
1. Steering shaft
a. Install kit extension, steering on steering gear
box with kit bolt (3/8” x 1 1/4” allen head). Do not
tighten. Carefully extend the mark from the Rack
and pinion along kit extension, steering.
WARNING
Verify the steering extension is securely installed as
specified in the instructions. Failure to do so may
cause steering malfunction, resulting in property dam-
age or serious personal injury.
Kit Bracket,
Straight
Kit Washer
(1/4” SAE),
Kit Nut
(1/4” Nylock)
Fuel / Brake
Line Bracket
Wheel
Well Side
Bolt
Rack &
Pinion
Kit Bolt (3/8”
x 1 1/4” Allen
Head)
Kit Extension,
Steering
Marks
Steering Shaft
b. Install steering shaft on kit steering extension,
ensuring marks on steering shaft, kit steering
extension and gear box are aligned.
c. Apply a few drops of Loctite® to factory bolt and
kit bolt (3/8” x 1 1/4” Allen head).
d. Install and tighten bolts to 33 lb.-ft.
2. Inner fender well drivers side
a. Install two power steering cooler line brackets on
a kit bracket C-shaped and a kit bracket J-
shaped with two kit bolts (1/4” x 1”), four kit
washers (1/4” SAE), and two kit nuts nylock (1/
4”).
b. Install kit bracket, C-shaped and a kit bracket,
J-shaped on frame with two bolts.
c. Install wiring harness on frame with kit zip-tie.
Kit Bracket, C-shaped
Kit Bolt (1/4” X 1”),
Kit Washer (1/4” SAE),
& Kit Nuts Nylock (1/4”)
Kit Bracket, J-shaped
Frame
Bolt
Kit Bolt (1/4” X 1”),
Kit Washer (1/4” SAE),
& Kit Nuts Nylock (1/4”)
Bolt
Wiring
Harness
Zip-Tie
Frame