Filter
Top Products
15 ‘04-’05 Nissan Titan - Kit 40053
b. Install and connect two wiring harness connec-
tors on rear bumper and wiring harness.
c. Install kit zip-tie on wiring harness.
3. Spare tire winch mechanism
a. Remove cotter key, U-bracket, plate, spring, and
bell-bracket from chain and winch mechanism.
b. Position chain through, and position winch
mechanism on top of frame cross member with
kit bolt (M10-1.25 X 100mm) and kit tube
spacer. Do not tighten. Mark where chain con-
tacts frame cross member and remove winch
mechanisism.
Bumper
Bracket
Wiring
Harness
Connectors
Wiring
Harness
Wiring
Harness
Zip Tie
Cotter Key
Bell-bracket
U-bracket
Plate
Spring
Chain
Winch Mechanism
Chain
Frame Cross
Member
Kit Bolt (M10-
1.25 X
100mm)
Mark
Kit Tube Spacer
c. Trim frame cross member as shown.
d. Install chain through, and position crank mecha-
nism on top of frame cross member with two kit
bolts (M10-1.25 X 100mm), kit washers (7/16”
SAE), and kit tube spacers. Ensure crank
mechanism and chain operates correctly
through frame cross member.
e. Install bell-bracket, spring, plate, U-bracket, and
cotter key on chain and winch mechanism.
f. Install spare tire according to owners manual.
Ensure chain operates without catching on
frame cross member.
4. Fuel filler
WARNING
Use extreme caution when working near the fuel lines
and the fuel tank. Clean up spilled fuel immediately. A
spark could cause an explosion or fire resulting in seri-
ous personal injury and property damage.
Chain
Frame Cross
Member
Kit Bolt (M10-1.25 X 100mm),
Kit Washers (7/16” SAE)
& Kit Tube Spacer
Trim
Cotter Key
Bell-bracket
U-bracket
Plate
Spring
Chain