Filter
Top Products
12 ‘04-’05 Nissan Titan - Kit 40053
b. Remove three bolts from cab bushings on pas-
senger side.
2. Cab passenger side
a. Using a hydraulic jack and a wooden block,
slowly lift passenger side of cab a little more
than 3”.
b. Install a kit block (3” x 2”) on the core support
bushings and two kit blocks (3” x 3”) on bush-
ings on each cab mount bushings.
WARNING
Use extreme caution when lifting body from frame. To
prevent serious personal injury, ensure the hydraulic
jack is securely placed. Keep your hands out from
between the body and frame.
CAUTION
Continually check hoses, wires, lines, etc. to be sure
that everything is flexing properly and not binding, or
damage to the vehicle could result. Be especially care-
ful of the a/c hoses at the fire wall, the belt pulley, and
at the core support. Ensure brake lines stretch while
lifting. Bending the lines to gain ample slack may be
necessary. Be extremely careful not to kink the lines.
CAUTION
The kit blocks must be installed in addition to the fac-
tory bushings. Installing the kit blocks without the fac-
tory bushings could result in damage to the vehicle or
serious personal injury.
Bolt
Bushing
Cab Mount
c. Install a kit bolt (M12-1.25 x 180mm) on each
cab mount. DO NOT tighten.
d. Lower cab onto kit blocks (3” x 3”).
3. Cab driver side
a. Repeat previous steps on driver side of cab.
b. Check cab-to-bed spacing according to previous
measurement.
c. Remove each kit bolt, one at a time, and apply a
few drops of Loctite® to threads and install kit
bolt (M12-1.25 x 180mm). Tighten kit bolts to
45 ft. lbs.
Bed
1. Prepare to lift bed from frame
a. Loosen, but DO NOT remove, bed mounting
bolts on driver side.
Kit Block (3” x 3”)
Bushing
Kit bolt (M12-1.25
x 180mm)
Bolt
Bed Mount