Filter
Top Products
ROLLING CODE PROGRAMMING
Rolling code garage door openers (or other roll-
ing code devices) which are “code protected”
and manufactured after 1996, may be deter-
mined by the following:
● Reference the garage door opener Owner’s
Manual for verification.
● The hand-held transmitter appears to pro-
gram the HomeLinkா Universal Transceiver
but does not activate the garage door.
● Press and hold the trained HomeLinkா but-
ton. If the garage door opener has the rolling
code feature, the HomeLinkா indicator light
will flash rapidly, then remain on after 2 sec-
onds.
To program the HomeLinkா Universal Transceiver
to a garage door opener with the rolling code
feature, follow theseinstructions after completing
the “Programming HomeLinkா” (the aid of a sec-
ond person may make the following procedures
quicker and easier).
1. Locate the training button on the garage
door opener motor unit. Exact location and
color of the button may vary by garage door
opener brand. If there is difficulty locating
the training button, reference the garage
door opener Owner’s Manual.
2. Press the training button on the garage door
opener motor unit (which may activate a
training light).
NOTE:
Following step 2, there are 30 seconds in
which to initiate step 3.
3. Firmly press and release the programmed
HomeLinkா button a second time to com-
plete the training process. (Some garage
door openers may require you to do this
procedure a third time to complete the train-
ing.)
The garage door opener should now recognize
the HomeLinkா Universal Transceiver and acti-
vate when the HomeLinkா button is pressed. The
remaining two buttons may now be programmed
(if not yet programmed, follow steps 2 through 4
in the “Programming HomeLinkா” procedures
earlier in this section).
REPROGRAMMING A SINGLE
HOMELINKா BUTTON
To reprogram a HomeLinkா Universal Transceiver
button, complete the following.
1. Press and hold the desired HomeLinkா but-
ton. Do not release the button until step 4
has been completed.
2. When the indicator light begins to flash
slowly (after 20 seconds), position the
hand-held transmitter1-3inches (26 - 76
mm) away from the HomeLinkா surface.
3. Press and hold the hand-held transmitter
button.
4. The HomeLinkா indicator light will flash, first
slowly and then rapidly. When the indicator
light begins to flash rapidly, release both
buttons.
The HomeLinkா Universal Transceiver button has
now been reprogrammed. The new device can
be activated by pushing the HomeLinkா button
that was just programmed. This procedure will
not affect any other programmed HomeLinkா
buttons.
IF YOUR VEHICLE IS STOLEN
If your vehicle is stolen, you should change the
codes of any non-rolling code device that has
been programmed into HomeLinkா. Consult the
Owner’s Manual of each device or call the manu-
facturer or dealer of those devices for additional
information.
When your vehicle is recovered, you will
need to reprogram the HomeLinkா Univer-
sal Transceiver with your new transmitter
information.
Instruments and controls 2-51
੬ REVIEW COPY—
2009 Altima Hybrid Electric
(ahv)
Owners Manual—Canadian_French (fr_can)
06/16/08—debbie
੭