Filter
Top Products
5. Remove any additional slack from the child
restraint; press downward and rearward
firmly in the center of the child restraint to
compressthe vehicle seat cushionand seat-
back while pulling up on the seat belt.
6. After attaching the child restraint, test it be-
foreyou place thechild in it. Pushit from side
to side while holding the seat near the seat
belt path. The child restraint should not
movemore than 1 inch (25mm), from side to
side. Try to tug it forward and check to see if
the belt holds the restraint in place. If the
restraint is not secure, tighten the belt as
necessary, or put the restraint in another
seat and test it again. You may need to try a
different child restraint. Not all child re-
straints fit in all types of vehicles.
7. Check that the retractor is in the ALR mode
by trying to pull more seat belt out of the
retractor. If you cannot pull any more seat
belt webbing out of the retractor, the retrac-
tor is in the ALR mode.
8. Check to make sure that the child restraint is
properly secured prior to each use. If the
seat belt is not locked, repeat steps 3
through 7.
After the child restraint is removed and the seat
belt fully retracted, the ALR mode (child restraint
mode) is canceled.
Rear-facing – step 5
WRS0762
Rear-facing – step 6
WRS0763
1-38 Safety—Seats, seat belts and supplemental restraint system
੬ REVIEW COPY—
2009 Altima (alt)
Owners Manual (owners)—USA_English (nna)
02/03/09—debbie
੭