Filter
Top Products
NOTE:
Following step 2, there are 30 seconds in
which to initiate step 3.
3. Firmly press and release the programmed
HomeLinkா button a second time to com-
plete the training process. (Some garage
door openers may require you to do this
procedure a third time to complete the train-
ing.)
The garage door opener should now recognize
the HomeLinkா Universal Transceiver and acti-
vate when the HomeLinkா button is pressed. The
remaining two buttons may now be programmed
(if not yet programmed, follow steps 2 through 4
in the “Programming HomeLinkா” procedures
earlier in this section).
REPROGRAMMING A SINGLE
HOMELINKா BUTTON
To reprogram a HomeLinkா Universal Transceiver
button, complete the following.
1. Press and hold the desired HomeLinkா but-
ton. Do not release the button until step 4
has been completed.
2. When the indicator light begins to flash
slowly (after 20 seconds), position the
hand-held transmitter1-3inches (26 - 76
mm) away from the HomeLinkா surface.
3. Press and hold the hand-held transmitter
button.
4. The HomeLinkா indicator light will flash, first
slowly and then rapidly. When the indicator
light begins to flash rapidly, release both
buttons.
The HomeLinkா Universal Transceiver button has
now been reprogrammed. The new device can
be activated by pushing the HomeLinkா button
that was just programmed. This procedure will
not affect any other programmed HomeLinkா
buttons.
IF YOUR VEHICLE IS STOLEN
If your vehicle is stolen, you should change the
codes of any non-rolling code device that has
been programmed into HomeLinkா. Consult the
Owner’s Manual of each device or call the manu-
facturer or dealer of those devices for additional
information.
When your vehicle is recovered, you will
need to reprogram the HomeLinkா Univer-
sal Transceiver with your new transmitter
information.
FCC Notice:
This device complies with FCC rules part 15
and RSS-210 of Industry Canada. Opera-
tion is subject to the following two condi-
tions:
(1) This device may not cause harmful in-
terference and (2) This device must accept
any interference that may be received, in-
cluding interference that may cause undes-
ired operation.
This transmitter has been tested and com-
plies with FCC and DOC/MDC rules.
Changes or modifications not expressly ap-
proved by the party responsible for compli-
ance could void the user’s authority to op-
erate the equipment.
DOC: ISTC 1763K1313
FCC I.D. CV2V67690
2-54 Instruments and controls
੬ REVIEW COPY—
2009 Altima (alt)
Owners Manual (owners)—USA_English (nna)
02/03/09—debbie
੭