Filter
Top Products
First, secure the child restraint with the LATCH
System (rear outboard seating positions only) or
the seat belt, as applicable.
᭺
1
Flip up the anchor cover from the anchor
point which is located directly behind the
child seat.
᭺
2
Position the top tether strap over the top of
the seatback.
᭺
3
Secure the tether strap to the tether anchor
bracket that provides the straightest installa-
tion.
4. Tighten the tether strap according to the
manufacturer’s instructions to remove any
slack.
If you have any questions when installing a
top tether strap child restraint on the rear
seat, consult your NISSAN dealer for de-
tails.
CHILD RESTRAINT INSTALLATION
USING LATCH
WARNING
● Attach LATCH compatible child re-
straints only at the locations shown. For
the LATCH lower anchor locations, see
“Lower Anchors and Tethers for Chil-
dren System (LATCH)” in this section. If
a child restraint is not secured properly,
your child could be seriously injured or
killed in an accident.
● The LATCH anchors are designed to
withstand only those loads imposed by
correctly fitted child restraints. Under
no circumstance are they to be used for
adult seat belts or harnesses.
● Inspect the lower anchors by inserting
your fingers into the lower anchor area
and feeling to make sure there are no
obstructions over the LATCH anchors,
such as seat belt webbing or seat cush-
ion material. The child restraint will not
be secured properly if the LATCH an-
chors are obstructed.
Front-facing
Follow these steps to install a front-facing child
restraint using LATCH:
LRS0798
1-26 Safety—Seats, seat belts and supplemental restraint system
੬ REVIEW COPY—
2008 Altima (alt)
Owners Manual—USA_English (nna)
02/12/08—debbie
੭