Filter
Top Products
PROGRAMMING HOMELINKா
1. To begin, press and hold the two outer
HomeLinkா buttons (to clear the memory)
until the indicator light
᭺
1
blinks (after
20 seconds). Release both buttons.
2. Position the end of the hand-held transmitter
1 - 3 inches (26 - 76 mm) away from the
HomeLinkா surface.
3. Using both hands, simultaneously press and
hold both the HomeLinkா button you want to
program and the hand-held transmitter but-
ton.
DO NOT release the buttons until step 4 has
been completed.
4. Hold down both buttons until the indicator
light on the HomeLinkா flashes, changing
from a “slow blink” to a “rapidly flashing
blink”. This could take up to 90 seconds.
When the indicator light flashes rapidly, both
buttons may be released. The rapidly flash-
ing light indicates successful programming.
To activate the garage door or other pro-
grammed device, press and hold the pro-
grammed HomeLinkா button — releasing
when the device begins to activate.
5. If the indicator light on the HomeLinkா blinks
rapidly for 2 seconds and then turns solid,
HomeLinkா has picked up a “rolling code”
garage door opener signal. You will need to
proceed with the next steps to train the
HomeLinkா to complete the programming
which may require a ladder and another per-
son for convenience.
6. Press and release the “smart” or “learn” pro-
gram button located on the garage door
opener’s motor to activate the “training
mode”. This button is usually located near
the antenna wire that hangs down from the
motor. If the wire originates from under a
light lens, you will need to remove the lens to
access the program button.
WIC0986 WIC0987
2-50 Instruments and controls
੬ REVIEW COPY—
2008 Altima (alt)
Owners Manual—USA_English (nna)
02/13/08—debbie
੭