Filter
Top Products
NOTE:
Once you have pressed and released the
program button on the garage door open-
er’s motor and the “training light”is lit, you
have 30 seconds in which to perform step 7.
Use the help of a second person for conve-
nience to assist when performing this step.
7. Within 30 seconds of pressing and releas-
ing the garage door opener program button,
quickly and firmly press and release the
HomeLinkா button you’ve just programmed.
Press and release the HomeLinkா button up
to 3 times to complete the training.
8. Your HomeLinkா button should now be pro-
grammed. (To program the remaining
HomeLinkா buttons for additional door or
gate openers, follow steps 2-4 only.)
NOTE:
Do not repeat step 1 unless you want to
“clear” all previously programmed
HomeLinkா buttons.
If you have any questions or are having difficulty
programming your HomeLinkா buttons, refer to
the HomeLinkா web site at: www.homelink.com
or call 1-800-355-3515.
PROGRAMMING HOMELINKா FOR
CANADIAN CUSTOMERS
Prior to 1992, D.O.C. regulations required hand-
held transmitters to stop transmitting after 2 sec-
onds. To program your hand-held transmitter to
HomeLinkா, continue to press and hold the
HomeLinkா button (see steps 2 - 4 under “Pro-
gramming HomeLinkா”) while you press and re-
press (“cycle”) your hand-held transmitters every
2 seconds until the indicator light flashes rapidly
(indicating successful programming).
NOTE:
When programming a garage door opener,
etc., it is advised to unplug the device dur-
ing the “cycling” process to prevent pos-
sible damage to the garage door opener
components.
OPERATING THE HOMELINKா
UNIVERSAL TRANSCEIVER
The HomeLinkா Universal Transceiver (once pro-
grammed) may now be used to activate the ga-
rage door, etc. To operate, simply press the ap-
propriate programmed HomeLinkா Universal
Transceiver button. The red indicator light will
illuminate while the signal is being transmitted.
PROGRAMMING TROUBLE-
DIAGNOSIS
If the HomeLinkா does notquickly learn the hand-
held transmitter information:
● replace the hand-held transmitter batteries
with new batteries.
● position the hand-held transmitter with its
battery area facing away from the
HomeLinkா surface.
● press and hold both the HomeLinkா and
hand-held transmitter buttons without inter-
ruption.
● position the hand-held transmitter 1 -
3 inches (26 - 76 mm) away from the
HomeLinkா surface. Hold the transmitter in
that position for up to 15 seconds. If
HomeLinkா is not programmed within that
time, try holding the transmitter in another
position – keeping the indicator light in view
at all times.
If you continue to have programming difficulties,
please contact the NISSAN Consumer Affairs
Department. The phone numbers are located in
the Foreword of this manual.
Instruments and controls 2-51
੬ REVIEW COPY—
2008 Altima (alt)
Owners Manual—USA_English (nna)
02/13/08—debbie
੭