Navman 5100I GPS Receiver User Manual


 
7
TRACKER 5100/5100i/5500/5500i Installation and Operation Manual
NAVMAN
1-3 Removing and replacing the display unit
If the display unit is bracket mounted then the display
unit can easily be removed and replaced for security
or protection.
Removing the display unit:
1 Turn the TRACKER off by holding
until the
display turns off.
2 Push the dust cover over the display unit.
3 Hold the display unit with one hand. Loosen
the knob on the mounting bracket and carefully
lift the unit off the mounting bracket.
4 The display unit has some cables plugged into
the back.
Unplug each black plug by turning the locking
collar a quarter turn anticlockwise and pulling
the plug out.
If there is a gold plug, unscrew the locking
collar anticlockwise and pull the plug out.
5 Push the attached dust covers over the
exposed ends of the plugs to protect them.
6 Store the display unit in a safe place, such as
the optional NAVMAN carry bag.
Replacing the display unit
1 Remove the dust covers from the plugs. Plug
the black plugs into their sockets on the back
of the display unit:
Match the colour on the end of the plug to
the colour of the nut on the socket.
Hold the plug against the socket and rotate
the plug until it slides into the socket.
Lock the plug in place by pushing the
locking collar towards the socket and
turning it a quarter turn clockwise.
Nothing will be damaged if a cable is plugged
into the wrong socket by mistake.
2 If the unit has a gold plug:
Plug it into its socket on the back of the
display unit.
Hand tighten the locking collar clockwise -
do not overtighten.
3 Hold the display unit in place on the mounting
bracket shaft, with the rubber washer clamped
between the bracket and the display unit.
4 Adjust the tilt and rotation of the display for
best viewing and hand tighten the knob on the
mounting bracket. Remove the dust cover.
Pull card holder out of
TRACKER.
Pull any card out of holder.
Put card in case.
Card
Holder
Gold contacts under here
Push new card into holder.
Ensure the gold contacts
are on the outer edge and
underneath (see above).
Keep the card’s case.
Push card holder fully into
TRACKER.
Changing the plug-in card
4
31 2
Warning: Keep the holder in place in the TRACKER at all times to prevent
moisture from entering card compartment.