Filter
Top Products
COMPONENTS
1. — Used for the transportation of
material. Tub holds approximately 16 cubic feet (0.59
cubic yards) of water.
2. — This handle bar is used
to steer the buggy. When driving the buggy, use both
hands and hold onto both handle bar grips.
3. — In the event of an emergency, press this
button to stop the engine.
4. — Remove this cap to add fuel. Tank
holds approximately 5.5 U.S. gallons. Do not over fill.
5. — Sets the buggy's travel speed. When
fully depressed, the buggy will be at FULL speed. When
released, the buggy will STOP.
6. — When this lever is activated
(pulled down), the parking brake will be set. To release
the brake, pull the lever upwards.
7. — When the travel lever is pushed
forward the buggy will travel in the forward direction.
Placing the travel lever in the backward position will
cause the buggy to travel in the reverse direction.
Center position is neutral.
8. — Press this pedal with the right foot to
stop the buggy.
9. — When the buggy is in use, the
operator shall ALWAYS stand on this platform while
holding onto the handle bar (steering).
Figure 2. WBH16EAWD Power Buggy
Components
10. — This machine uses either an electric or a
recoil start Briggs & Stratton 18HP Vanguard engine.
11. — Use this pedal to place the tub in the
dump position (vertical). Press pedal a second time to
return tub to the travel position (horizontal).
12. — Used for electric start.
13. — Use these fork lift pockets to lift
the power buggy with a forklift. Remember to insert the
forks of the fork lift a minimum of 24 inches into power
buggy's fork lift pockets.
14. — Use this lever forward to place
the tub in the dump position (vertical), move the lever
backward to return the tub to travel position (horizontal).
15. — Use this hook to tow the buggy if it
gets stuck. This hook is NOT intended for towing the
buggy on public roads at high speeds.
16. — Engaging the traction
assist system while in AWD mode provides enhanced
traction control.
17. — Use when AWD is
needed for extended period of time. Toggle the switch
to AWD to engage the system.
NOTICE
The traction assist switch is not intended for extended
use as it may cause increased hydraulic temperature
and cause damage to the machine.