Multiquip Qp4tZtMpXF Automobile Parts User Manual


 
PAGE 16 — QP4TZT10P/TMP16F/TMPXF TRASH PUMP • OPERATION & PARTS MANUAL — REV. #1 (08/29/11)
BASIC ENGINE
HATZ DIESEL
scs
DIESEL
HATZ
1 2
3
4
5
6
7
8
9
11
FRONT VIEW
REAR VIEW
10
Figure 4. Engine Controls and Components
INITIAL SERVICING
The engine (Figure 4) must be checked for proper
lubrication and filled with fuel prior to operation. Refer
to the manufacturer’s engine manual for instructions and
details of operation and servicing.
1. Fuel Filler Cap/Fuel Tank — Pull this latch to add
diesel fuel to the tank. After refueling, always make
sure the fuel cap is latched properly. DO NOT over fill.
For additional information refer to engine owner's
manual.
2. Engine Lifting Straps/Cover — Remove the air
cleaner cover, then lift this cover (the one with decals
on it) to gain access to the engine lifting straps.
3. Air Cleaner/Cover — Prevents dirt and other debris
from entering the fuel system. Remove wing-nut on
side of air filter cover to gain access to filter element.
4. Speed Control Lever — This lever is connected to the
throttle control which is located on the side of the engine
compartment cover. Use this lever to control engine speed.
DANGER
Adding fuel to the tank should be
accomplished only when the engine is
stopped and has had an opportunity to
cool down. In the event of a fuel spill, DO
NOT attempt to start the engine until the
fuel residue has been completely wiped up, and the
area surrounding the engine is dry.
5. Dip Stick — Remove dipstick to determine if the engine
oil level is low. If low, add oil as specified.
6. Engine Motor Mounts — Attach these engine mounts
to the pump frame. Tighten securely.
7. Oil Filter — Remove this bolt to gain access (internal) to
the engine oil filter. Service the oil filter as recommended
in the maintenance section of this manual.
8. Oil Drain Plugs — There are two oil drain plugs, one
is underneath the flywheel, the other on the side of the
engine. Remove these plugs to drain engine oil from
the engine crankcase.
9. Crankshaft — Connect this shaft to the input of the
transmission.
10. Muffler — Used to reduce noise and emissions.
11. Nameplate — Contains information about the engine.
WARNING
Engine components can generate extreme
heat. To prevent burns, DO NOT touch
these areas while the engine is running or
immediately after operating. NEVER operate
the engine with the muffler removed.
NOTICE
Operating the engine without an air filter, with a
damaged air filter, or a filter in need of replacement will
allow dirt to enter the engine, causing rapid engine wear.