Filter
Top Products
PAGE 12 — G-55H GASOLINE VIBRATOR — OPERATION & PARTS MANUAL — REV. #0 (03/07/06)
G-55H GASOLINE VIBRATOR — MAJOR COMPONENTS
Figure 2. G-55H Gasoline Vibrator Components
Figure 2 shows the location of the components and general
maintenance parts. The function of each component is
described below:
5. Rear Belt Guard – Attaches to the V-belt housing and
prevents access to the pulleys or V-belts while the vibrator
is running. DO NOT operate the vibrator with this cover
removed.
6. V-belt Housing – Encloses the pulley's and v-belts.
Access is provided through openings in the front and
rear of the housing.
7. Vibrator Support Stand – Allows the vibrator base to
sit upright. A pivot mechanism allows the base to freely
pivot in a complete 360 degree circle for operators
convieniance.
1. Eccentric Bell End – Supports the spindle shaft and
upper pulley which drives the vibration function of the
G-55H. The flexible shaft and quick disconnect are
inserted into the open end of the Eccentric Bell.
2. 328V Quick Disconnect – Connect the flexible shaft to
the quick disconnect and insert into the eccentric bell.
This allows for rapid removal of the flexible shaft end
from the vibrator base.
3. Quick Disconnect Lock Pin – Pull up on the lock pin
and pull the flexible shaft out to release the quick
disconnect from the eccentric bell. To insert a flexible
shaft, pull up on the lock pin and insert the quick
disconnect fitting. Release the pin and turn the fitting
until the lock pin drops into one of the holes on the fitting
end.
4. Front Belt Guard – Attaches to the V-belt housing and
prevents access to the pulleys or V-belts while the vibrator
is running. DO NOT operate the vibrator with this cover