MANUAL TRANSMISSION (E -W) -
Transmission
22A-3-6
PWEE9508
E
May 1995Mitsubishi Motors Corporation
A
L
"
SPRING PIN/3RD AND 4TH SHIFT RAIL ASSEMBLY/
INPUT SHAFT/OUTPUT SHAFT REMOVAL
(1) Remove the spring pin from the 3rd and 4th gear selector
fork.
(2) Take both shafts together with the shift rail assembly
out of the clutch housing.
(3) Inspect the input shaft.
NOTE
The shaft must always be renewed in the event of wear
or damage. The shaft cannot be reconditioned.
A
M
"
INPUT SHAFT/OUTPUT SHAFT REMOVAL
(1) Take the two shafts out of the clutch housing together.
(2) Inspect the input shaft.
NOTE
The shaft must always be replaced in the event of wear
or damage. The shaft cannot be reconditioned.
RevisedPWEE9508-BMitsubishi Motors Corporation
May 1996
E
<F5MR3>
RMT0007
RMT0008
RMT0009