Filter
Top Products
9
6
Using the scored lines as a guide, cut and
remove the dashed portions of
Faceplate #2.
Disconnect the negative battery terminal to
prevent an accidental short circuit. Remove
the knobs from the climate controls. Using a
small screwdriver, pry out on the climate
control trim panel and remove. Remove (2)
screws securing the factory dummy plate
and discard the plate.
1
NISSAN Maxima 1982-84
2
3
Slide Mounting Tabs #8 into slots "C" on Bracket Set #14. The
Mounting Tabs, Bracket and Bracket slots can be identified by the
stamped letter on each component. Skip to the Installation
Instructions for ALL VEHICLES on Page #14.
"C"
Using the scored lines as a guide, cut
and remove the dashed portions of
Faceplate #2. (This model does NOT
require the use of a Radio Housing or
Mounting Brackets).
Disconnect the negative battery terminal to
prevent an accidental short circuit. Remove (2)
Phillips screws from the top of the dash trim
bezel. Remove the ashtray and (1) screw
exposed on the ashtray bracket. Remove the
bracket. Unclip the dash trim bezel and
disconnect the wiring. Remove (2) Phillips
screws securing the factory head unit to the shelf.
Remove the unit and disconnect the wiring.
1
NISSAN Pulsar 1983-86 / Sentra 1982-86
2
3
2-SHAFT HEAD UNITS: Slide the aftermarket head unit into the dash trim bezel, place the
Faceplate and Shaft Masks over the radio shafts and secure with shaft nuts. (see Fig. A).
Make wiring connections and re-attach the dash trim bezel.
DIN HEAD UNITS: Cut and remove the shaft supports from the Faceplate. Cut a DIN opening
in the dash trim bezel. Slide the DIN cage through the Faceplate into the dash trim bezel and
secure by bending the metal locking tabs down. Make wiring connections and slide the
aftermarket head unit into the cage until secure. (see Fig. B). Re-attach the dash trim bezel.
Fig. B
Fig. A