Filter
Top Products
13
2
3
Disconnect the negative battery terminal to
prevent an accidental short circuit. Remove
(1) #10 Phillips screw from each side of the
center console. Unsnap the coin tray and
remove (2) #10 Phillips screws exposed. Lift
the storage box carpet out and remove (2)
#10 Phillips screws exposed. Remove the
ashtray and (2) #8 Phillips screws exposed.
Remove the dash trim bezel. Remove (4)
screws securing the factory head unit and
disconnect the wiring.
1
NISSAN 200SX 1984-88
2
"B"
"B"
Locate Faceplate #2. (It is NOT necessary
to cut the Faceplate).
Slide Mounting Tabs #8 into slots "B" on Brackets #13 and #14.
The Mounting Tabs, Brackets and Bracket slots can be identified
by the stamped letter on each component. Skip to the Installation
Instructions for ALL VEHICLES on Page #14.
3
"B"
"B"
Disconnect the negative battery terminal to
prevent an accidental short circuit. Remove
the ashtray and (2) screws exposed at the
base of the dash trim bezel. Remove (2)
screws above the climate controls and
unclip the bezel. Remove (4) screws
securing the factory head unit and
disconnect the wiring.
1
NISSAN Stanza 1987-89
2
Using the scored lines as a guide, cut and
remove the dashed portions of Faceplate
#1.
Slide Mounting Tabs #8 into slots "B" on Bracket Set #9. The
Mounting Tabs, Bracket and Bracket slots can be identified by the
stamped letter on each component. Skip to the Installation
Instructions for ALL VEHICLES on Page #14.