Mercedes-Benz 2011 ML450 HYBRID SUV Automobile User Manual


 
X
Keep locking button : on the door handle
pressed until the side windows and the
sliding sunroof are fully closed.
X
Make sure that all the side windows and the
sliding sunroof are closed.
X
To interrupt convenience closing:
release locking button : on the door
handle.
Resetting the side windows
You must reset each side window if:
R
the battery has been disconnected or has
become discharged.
R
the side window can no longer be fully
opened or closed.
X
Close all the doors.
X
Turn the SmartKey to position 2 in the
ignition lock.
X
Pull the corresponding switch on the door
control panel until the side window is
completely closed. (Y page 85)
X
Hold the switch for an additional second.
If the side window opens again slightly:
X
Immediately pull the corresponding switch
on the door control panel until the side
window is completely closed (Y page 85).
X
Hold the switch for an additional second.
X
If the corresponding side window remains
closed after the button has been released,
the side window has been reset correctly.
If this is not the case, repeat the steps
above again.
Problems with the side windows
Problem: a side window cannot be closed
because objects are trapped between the
side window and the door frame.
X
Remove the objects.
X
Close the side window.
Problem: a side window cannot be closed
because objects in the guide rail are
preventing the window from being raised.
X
Remove the objects.
X
Close the side window.
Problem: a side window cannot be closed,
and you cannot see the cause.
G
Warning
Closing the side windows with increased force
or without the anti-entrapment feature could
lead to serious or even fatal injury. Make sure
that nobody can become trapped when
closing the side windows.
If a side window is obstructed during closing
and reopens again slightly:
X
Immediately after the window blocks, pull
the corresponding switch again until the
side window has closed.
The side window is closed with increased
force.
If a side window is obstructed again during
closing and reopens again slightly:
X
Immediately after the window blocks, pull
the corresponding switch again until the
side window has closed.
The side window is closed without the anti-
entrapment feature.
G
Warning!
Pulling and holding the switch to close the
door window immediately after it had been
blocked two times will cause the door window
to close without the anti-entrapment feature
for as long as you hold the switch.
Side windows
87
Opening and closing
BA 164.1 USA, CA Edition B 2011; 1; 2, en-US
d2mskot Version: 3.0.3.5
2010-04-21T17:25:06+02:00 - Seite 87
Z