Filter
Top Products
your safety and the safety of others, we
recommend that you pull over to a safe
location and stop before placing or taking a
telephone call. If you choose to use the
telephone while driving, please use the hands-
free device and only use the telephone when
weather, road and traffic conditions permit.
Some jurisdictions prohibit the driver from
using a mobile phone while driving a vehicle.
Bear in mind that at a speed of just 30 mph
(approximately 50 km/h), your vehicle is
covering a distance of 44 feet (approximately
14 m) every second.
You can connect your telephone to the
COMAND system via Bluetooth
®
, see
separate COMAND system operating
instructions.
X
Switch on the COMAND system.
Refer to separate COMAND system
operating instructions.
X
Press button U or V repeatedly until
the message TEL appears in the
multifunction display.
One of the following messages will appear
in the multifunction display:
R
No Service: No network is available.
R
Bluetooth Ready: The telephone has
not been connected to the COMAND
system via Bluetooth
®
yet.
X
Connect the telephone to the
COMAND system via Bluetooth
®
.
R
Ready or name of the network provider
(if available): The telephone has found a
network and is ready for use. You can
operate it using the control system.
Answering a call
When your telephone is ready to receive calls,
you can answer a call at any time. In the
multifunction display you will then see the
following message, or if available, the caller
ID (number or name):
X
Press button 6.
You have answered the call.
Ending a call or rejecting an incoming
call
X
Press button ~.
Dialing a number from the phone book
When your telephone is ready to receive calls,
you may select and dial a number from the
phone book at any time.
X
Press button U or V repeatedly until
the message TEL appears in the
multifunction display.
X
Press button & or * repeatedly until
the desired name appears in the
multifunction display.
If you press and hold button & or
* for longer than 1 second, the system
scrolls rapidly through the list of names
until you release the button again.
The stored names are displayed in
alphabetical order.
X
Press button 6.
The control system dials the selected
phone number.
If the connection is successful and this
feature is supported by your network
provider, the name of the party (if stored in
126
Control system
Controls in detail
219_AKB; 4; 54, en-US
d2ureepe, Version: 2.11.8.1
2009-05-11T16:21:02+02:00 - Seite 126