Filter
Top Products
Control system
137
R
License plate lamps
R
Side marker lamps
For more information on the daytime running
lamp mode, see “Lighting” (Y page 97).
For safety reasons, resetting all the functions
of all submenus to the factory settings while
driving (Y page 132) will not deactivate the
daytime running lamp mode.
The following message appears in the
multifunction display:
Cannot be completely reset to
factory settings while driving.
Setting locator lighting
With the locator lighting feature activated and
the exterior lamp switch in position U, the
following lamps will come on during darkness
when the vehicle is unlocked using button
k on the SmartKey:
R
Parking lamps
R
Tail lamps
R
License plate lamps
R
Side marker lamps
The locator lighting goes out when the driver’s
door is opened.
If you do not open the driver’s door after
unlocking the vehicle with the SmartKey, the
lamps will go out automatically after
approximately 40 seconds.
X
Move the selection marker with button
æ or ç to the Lighting submenu.
X
Press button j or k repeatedly until
the message Surround Light.
Function appears in the multifunction
display.
The selection marker is on the current
setting.
X
Press button æ or ç to switch the
locator lighting function On or Off.
X
Turn the exterior lamp switch to position
U when exiting the vehicle.
The locator lighting feature is activated.
Setting night security illumination
(Headlamps delayed shut-off feature)
Use this function to set whether you would
like the exterior lamps to remain on for
15 seconds during darkness after exiting the
vehicle and closing all doors.
With the headlamps delayed shut-off feature
activated and the exterior lamp switch in
position U before the engine is turned off,
the following lamps will come on when the
engine is turned off:
R
Parking lamps
R
Tail lamps
R
License plate lamps
R
Side marker lamps
R
Front fog lamps
If, after turning off the engine, you do not
open a door or do not close an opened door,
the lamps will automatically go out after
60 seconds.
X
Move the selection marker with button
æ or ç to the Lighting submenu.
X
Press button j or k repeatedly until
the message Headlamps Delayed Shut-
off appears in the multifunction display.
The selection marker is on the current
setting.
Controls in detail
Z