Filter
Top Products
438
Practical hints
Flat tire
̈ Screw the air pump’s air hose 5 onto
flange 6 of the TIREFIT container.
̈ Stick TIREFIT container 1 upside
down into notch 3 of the electric air
pump.
7 Tire valve
8 Electric air pump switch
9 Air hose with pressure gauge and vent
screw
a Filler hose
̈ Unscrew the valve cap from tire
valve 7.
̈ Screw filler hose a onto tire valve 7.
̈ Insert electrical plug 4 into vehicle
cigarette lighter socket (
୴ page 282)
or the power outlet in the rear passen-
ger compartment (
୴ page 283).
̈ Turn the SmartKey in the starter switch
to position 1 (
୴ page 36).
Vehicles with KEYLESS-GO*:
̈ Press the KEYLESS-GO* start/stop
button (
୴ page 37) on the gear se-
lector lever once. Do not depress
brake pedal.
̈ Press I on electric air pump switch 8.
The electric air pump should now
switch on and inflate the tire.
After 5 minutes, the pressure gauge must
display at least 26 psi (1.8 bar). The air
hose can become hot during inflation.
Please exercise appropriate caution.
̈ If this tire inflation pressure is not
attained:
̈ Turn off the electric air pump, de-
tach the filler hose from the tire
valve, and drive vehicle back and
forth very slowly approximately
30 ft (10 m).
This serves to better distribute the
TIREFIT sealant material inside the
tire.
̈ Unscrew the air pump’s air hose 5
from flange 6 of the TIREFIT
container.
̈ Screw air hose 5 onto tire
valve 7.
̈ Inflate the tire again.
Warning! G
Observe safety instructions on air pump
label.
!
Do not operate the electric air pump longer
than 6 minutes without interruption. Otherwise it
may overheat.
୴୴