Filter
Top Products
209
Controls in detail
Power windows
̈ Switch on the ignition (୴ page 34).
Opening the windows
̈ Press switch 1 to 4 at the
symbol k to the resistance point.
The corresponding window will move
downwards until you release the
switch.
Closing the windows
̈ Press switch 1 to 4 at the
symbol j to the resistance point.
The corresponding window will move
upwards until you release the switch.
Fully opening the windows
(Express-open)
̈ Press switch 1 to 4 at the
symbol k past the resistance point
and release.
The corresponding window opens com-
pletely.
Fully closing the windows
(Express-close)
̈ Press switch 1 to 4 at the
symbol j past the resistance point
and release.
The corresponding window closes com-
pletely.
i
Operating the windows from the rear is
not possible if you activate the override
switch (
୴ page 77).
i
With the SmartKey in starter switch po-
sition 0 or removed from the starter
switch, the power windows can be op-
erated:
ț until you open the driver’s or front
passenger door
ț for at least five minutes
Warning! G
If you press and hold the switch up when
closing the window, and upward movement
of the window is blocked by some obstruc-
tion including but not limited to arms, hands,
fingers, etc., the automatic reversal will not
operate.
Warning! G
Driver’s door only:
If within five seconds you again press the
switch past the resistance point and re-
lease, the automatic reversal will not func-
tion.
!
If the upward movement of the window
is blocked during the closing proce-
dure, the window will stop and open
slightly. Remove the obstruction, press
the respective power window switch at
the symbol j again past the resis-
tance point and release. If the window
୴୴