Filter
Top Products
250
Controls in detail
Soft top
Locking the soft top after raising/low-
ering
If the soft top is not properly locked, lock it
as described below.
Unlocked status noticed when stopped
̈ Switch on the ignition (୴ page 36).
̈ To lock the soft top in its fully closed
position, press soft top switch.
The message
Top closed
will be shown
in the multifunction display.
or:
̈ To lock the soft top in its fully opened
position, pull up on the soft top switch.
The message
Top open
will be shown in
the multifunction display.
Unlocked status noticed while driving
̈ Stop the vehicle.
̈ Leave the ignition switched on.
̈ To lock the soft top in its fully closed
position, press soft top switch.
The message
Top closed
will be shown
in the multifunction display.
or:
̈ To lock the soft top in its fully opened
position, pull up on the soft top switch.
The message
Top open
will be shown in
the multifunction display.
Warning! G
The soft top is not fully closed and locked or
not fully opened if:
ț the message
Top in operation!
is
shown in the multifunction display
ț a warning sounds for 10 seconds and
the message
Lock top
is shown in the
multifunction display when starting to
drive
To prevent possible accidents, drive the ve-
hicle only with the soft top either completely
closed and locked, or fully lowered into its
storage compartment.
Warning! G
Stop the vehicle and lock the soft top before
continuing to drive. You could otherwise en-
danger yourself and others.