Filter
Top Products
173
Controls in detail
Automatic transmission
Downshifting
̈ Press button 1 on the left side of the
steering wheel.
The transmission will shift to the next
lower gear as permitted by the shift
program. This action simultaneously limits
the gear range of the transmission
(
୴ page 166) when you are driving in the
automatic program mode (C or S).
Upshifting
̈ Press button 2 on the right side of the
steering wheel.
The transmission will shift to the next
higher gear as permitted by the shift
program. This action simultaneously
extends the gear range of the transmission
when you are driving in the automatic
program mode (C or S).
Manual shift program CLK 55 AMG
In the manual program mode M you can
change the gears manually on the steering
wheel (
୴ page 172) or by using the gear
selector lever (
୴ page 165).
i
You cannot shift with the steering
wheel gearshift buttons when the gear
selector lever is in position P, N or R.
The manual program mode M will not
be stored. When the engine is turned
off with the manual program mode M
selected, the transmission will go to
the automatic program mode (C or S)
when the engine is restarted.
The last selected program
mode (C or S) is switched on when the
engine is restarted in the automatic
program mode.
Warning! G
On slippery road surfaces, never downshift
in order to obtain braking action. This could
result in drive wheel slip and reduced
vehicle control. Your vehicle’s ABS will not
prevent this type of loss of control.
!
Allow engine to warm up under low
load use. Do not place full load on the
engine until the operating temperature
has been reached.
Shift into reverse gear R or parking
position P only when the vehicle is
stopped.
Avoid spinning of a drive wheel for an
extended period when driving off on
slippery road surfaces. This may cause
serious damage to the drivetrain which
is not covered by the Mercedes-Benz
Limited Warranty.