Filter
Top Products
53
Getting started
Parking and locking
Turning off with the SmartKey
̈ Turn the SmartKey in the starter switch
(
୴ page 31) to position 0 and remove
it.
The immobilizer is activated.
̈ Press the seat belt release button
(
୴ page 41).
Allow the retractor to completely re-
wind the seat belt by guiding the latch
plate.
̈ After exiting the vehicle press the lock
button ‹ on the SmartKey
(
୴ page 30).
All turn signal lamps flash three times.
The locking knobs on the doors move
down.
More information can be found in the
“Controls in detail” section (
୴ page 88).
Turning off with KEYLESS-GO*
̈ Place the gear selector lever in P.
̈ Press the KEYLESS-GO start/stop but-
ton to shut off the engine.
With the driver's door closed, the start-
er switch is now in position 1. With the
driver’s door opened, the starter switch
is set to position 0, same as SmartKey
removed from starter switch
(
୴ page 31).
i
The SmartKey can only be removed
from the starter switch with the gear
selector lever in position P.
!
With the SmartKey removed and the
driver’s door open, a warning sounds if
the vehicle’s exterior lamps are not
switched off.
Warning! G
To prevent possible personal injury, always
keep hands and fingers away from the door
openings when closing the doors. Be espe-
cially careful when small children are
around.
Before closing doors, make sure that there
is no possibility of someone getting caught
in a door during closing.
Warning! G
When leaving the vehicle, always remove the
SmartKey from the starter switch and lock
your vehicle. Do not leave children unat-
tended in the vehicle, or with access to an
unlocked vehicle. Unsupervised use of vehi-
cle may cause an accident and/or serious
personal injury.
୴୴