Filter
Top Products
The Brake System
Before running your AfterBurner, be
sure to do a brake check. With the car
runing at idle, roll it forward. It should roll
freely. Now roll the car forward again and
push the throttle trigger forward. The car
should come to a stop almost immediately.
If it does not stop instantly, adjust the brake
actuation rod to give more grip to the brake
pads. If the vehicle does not roll freely, then
adjust the rod in the opposite direction.
Adjusting the Throttle Trim
If your AfterBurner accelerates or stalls while in the neutral position, you
will need to adjust the throttle trim control. The throttle trim adjusts the
center point of the throttle servo, allowing you to fi ne tune the
operation of the transmitter throttle trigger.
Figure 15- Turn the wheel
right and the car goes right.
Turn the wheel left and the
car goes left.
Figure 16- brake actuation rod
11
Brakes and Throttle Trim