Filter
Top Products
2-16
Essential Safety Equipment
Child Restraint
Form No. 8R09-EA-02G
The passenger lap/shoulder belt can easily
be converted into the automatic locking
mode, which must be done to hold the
child-restraint system.
Some child-restraint systems also employ
specially designed LATCH attachments;
refer to "LATCH Child-Restraint
Systems" (page 2-18).
Follow these instructions when installing
a child-restraint system on the passenger’s
seat, unless you are attaching a LATCH-
equipped child-restraint system to the
LATCH lower anchors. Refer to "LATCH
Child-Restraint Systems" (page 2-18).
Before installing a rear-facing child-
restraint system, the passenger-side air
bag must be deactivated (page 2-23).
1. Slide the seat as far back as possible.
2. Secure the child-restraint system with
the lap portion of the lap/shoulder belt.
See the instructions on the child-
restraint system for belt routing
instructions.
3. To get the retractor into the automatic
locking mode, pull the shoulder belt
portion of the seat belt until the entire
length of the belt is out of the retractor.
4. Push the child-restraint system firmly
into the vehicle seat. Be sure the belt
retracts as snugly as possible. Clicking
from the retractor will be heard during
retraction if the system is in automatic
locking mode. If the belt does not lock
the seat down tight, repeat this step.
Installing a Child-
Restraint System
NOTE
Follow the child-restraint system
manufacturer’s instructions carefully.
If you are not sure whether you have a
LATCH system, check in the child-
restraint system manufacturer’s
instructions and follow them
accordingly. Depending on the type of
child-restraint system, it may not
employ seat belts which are in
automatic locking mode.
NOTE
Before installing a child-restraint
system, refer to "Passenger-Side Air
Bag Deactivation Switch" (page 2-23).
J07R_8R09_EA_02G.book Page 16 Monday, July 1, 2002 11:30 AM