Filter
Top Products
Black plate (50,1)
qLATCH Child-Restraint System
Installation Procedure (Rear
Outboard Seats)
1. Make sure the seatback is securely
latched by pushing it back until it is
fully locked.
2. Expand the area between the seat
bottom and the seatback slightly to
verify the locations of the LATCH
lower anchors.
3. Raise the head restraint to the top
locked position.
Refer to Head restraints on page 2-12.
4. Secure the child-restraint system using
BOTH LATCH lower anchors,
following the child-restraint system
manufacturer's instruction. Pull on the
child-restraint to be sure both anchors
are engaged.
5. If your child-restraint system came
equipped with a tether, that means it is
very important to properly secure the
tether for child safety. Please carefully
follow the child-restraint system
manufacturer's instructions when
installing tethers.
Anchor bracket location
Tether strap position
Anchor
bracket
Tether
strap
2-38
Essential SafetyEquipment
Child Restraint
Mazda6_8Z64-EA-08H_Edition1 Page50
Wednesday, June 25 2008 10:3 AM
Form No.8Z64-EA-08H