Filter
Top Products
Black plate (262,1)
Starting a Flooded Engine
If the engine does not start the first time,
perform the following procedure to start
the engine.
1. While the accelerator pedal is fully
depressed, turn the ignition switch to
the START position and crank the
engine for about 7 to 8 seconds.
2. Release the ignition switch and
accelerator pedal.
3. Start the engine as normally without
depressing the accelerator.
l
The fuel injection is cut by fully
depressing the accelerator pedal.
l
If the engine starts during Step 1, the
engine will rev up. Release the ignition
switch and accelerator pedal
immediately.
l
Avoid racing the engine or driving the
vehicle right after starting the engine.
l
Do not hold the ignition swi tch in the
START position for over 10 seconds. It
may damage the starter and drain the
battery.
l
If the engine still does not start using
the above procedure, have your vehicle
inspected by an Authorized Mazda
Dealer.
7-18
InCase of anEmergency
Emergency Starting
RX-8_8X44-EA-07G_Edition1 Page262
Friday, May 11 2007 5:4 PM
Form No.8X44-EA-07G