Mazda 2007 SPEED6 Automobile User Manual


 
Black plate (94,1)
CAUTION
l
Install the battery with the positive
pole (
) facing down. Battery
leakage could occur if it is not
installed correctly.
l
When replacing the battery, be
careful not to bend the electrica l
terminals or get oil on them. Also be
careful not to get dirt in the
transmitter as it could be damag ed.
l
There is the danger of explosion if
the battery is not correctly replaced.
l
Replace only with the same type
battery (CR1620 or equivalent).
l
Dispose of used batteries according
to the following instructions.
l
Insulate the plus and minus
terminals of the battery using
cellophane or equivalent tape.
l
Never disassemble.
l
Never throw the battery into fire
and/or water.
l
Never deform or crush.
Replacing the transmitter battery
1. Unfold the key (page 3-20).
2. Insert a small screwdriver into the slot
and push the tab to remove the key
from the transmitter.
Tab
3. Insert a small screwdriver into the slot
and gently pry open the transmitter.
4. Press the portion of the battery
indicated by A and remove the battery.
A
3-24
Knowing Your Mazda
Doors and Locks
Mazdaspeed6_8V77-EA-06F_Edition1 Page94
Tuesday, May 9 2006 10:44 AM
Form No.8V77-EA-06F