Magellan 3200 GPS Receiver User Manual


 
Installation 5
Attaching the Magellan Maestro to the Cradle
Align the tabs on the cradle to the indents on the
bottom of the Magellan Maestro. Swivel the
cradle up so that it is flush against the back of the
receiver and snap it into place.
Adjust the Mount for Optimum Viewing
Loosen the adjustment locking knobs and position the Magellan Maestro for optimum viewing. Once
set, tighten the locking knobs. (Never attempt to adjust the mount while driving.)
Connecting Power
Plug the end of the cigarette lighter adapter into a
12 VDC vehicle power receptacle. Connect the
other end of the cable to the Magellan Maestro’s
USB connector as shown. If there is power at the
receptacle, the Magellan Maestro will power on.
(Note: some vehicles apply power to the vehicle
power receptacle only when the ignition is on.)
Connecting Traffic Antenna
These instructions apply to those versions of the
Magellan Maestro that are “traffic-ready”.
Magellan Maestro’s with an external antenna input
(shown) are considered “traffic-ready”.
Plug the FM antenna connector from the Vehicle
Power Cable to the FM antenna jack on the
Magellan Maestro. See the section on Traffic for
additional set up information.
Traffic FM
Connector