Filter
Top Products
Installation 6
Check Connection and Final Adjustments
If the power indicator light on the vehicle power cable connector is on, power is being supplied to the
Magellan Maestro. If it is not on, check the cable connection to the vehicle power receptacle. If the
light is still not on, turn the vehicle’s ignition on.
Press the power button (located at the bottom right side of the Maestro) and hold down for a few
seconds. The Magellan Maestro will power on. Sit in a normal driving position and make any final
adjustments to the swivel mount for optimum viewing. Tighten the adjusting knobs on the swivel
mount to hold the Magellan Maestro firmly in place.
Press the power button again to turn the Magellan Maestro off and turn the ignition switch to the
vehicle to off. The Magellan Maestro is connected and ready for use.
Security
It is recommended that the Magellan Maestro is not left in plain view while unattended for reasons of
theft.
Please note that the Magellan Maestro is a receiver only and does not transmit GPS location signals.
The receiver nor the vehicle can be tracked using the Magellan Maestro.
Country Selection
When the receiver is turned on for the first time it may ask you to select the maps for the desired
country. Select the country you want to use by tapping on the item from the list.
If you are travelling in other countries you will may need to change the maps used by following these
steps.
1 From the Main Menu, tap on the right arrow to access the second page of the Main Menu.
2Tap on User Options.
3Tap on Destination Country.
4 Tap on the country desired.
The Destination Country option will display the countries that are available for the Magellan Maestro
you are using.