Filter
Top Products
have used your receiver, a screen will be displayed prompting
you to initialize your receiver. Press the enter key. When the
region screen appears, Use up/down arrow keys to highlight
the region where you are located. Enter mark. Use up/down
arrow keys to highlight country, province or state where you
are located. Enter mark. The elevation screen appears. Use the
arrow keys to enter your present elevation. Enter mark. From
the time field on the elevation screen. Use the arrow keys to
enter the local time and toggle between AM and PM. Enter
mark. From the date field on the elevation screen. Use the
arrow keys to input the date. Enter mark. During Initialization
at the Preference screen. Use the arrow keys to toggle
between marine and land. Enter mark. When you have chosen
the primary usage for your receiver, the status screen will be
displayed. At this point, you should go outside in an area
where you can get a clear view of the sky. Your Map 410 will
begin receiving data from the satellites in view and will display
the progress on the status screen. When your receiver has
computed a position fix, the map screen will be displayed. If
the map screen has been turned off then the position screen
will be displayed.
8 Question:
How do I save my position as a waypoint or landmark?
Answer:
From any screen (press and hold) enter mark you will then see
a screen with you latitude/longitude readings and also a
default name LMK00X, press and hold the mark key again to
save.
9 Question:
How do I create a GOTO route to my saved waypoint or
landmark?
Answer:
Press the GOTO key once then use up/down arrow keys to
highlight the user category and press enter mark. Use
up/down arrow keys to highlight the waypoint you just saved.
Enter mark.
10 Question:
How do I select the temp units in my Map 410 GPS?
Answer:
From the Sat Status screen press menu. Use up/down arrow
keys to highlight temp units and press enter mark. Use
up/down arrow keys to select either Fahrenheit or Celsius
11 Question:
How do I set a temperature calibration?
Answer:
From the sat status screen press menu. Use up/down arrow
keys to highlight temp calib and press enter mark. Use the
arrow keys to change the temperature. Enter mark. Use
up/down arrow keys to highlight save edits. Enter mark.
12 Question:
How do I view the secondary coordinate system from the
position screen in my Map 410 GPS?
Answer:
From the position screen, press the left/right arrows and the
lower half of the screen changes to display your present
position in the secondary coordinate system. The datums that
were selected under setup for each coordinate system are also
displayed.