Filter
Top Products
40
Press the
↓ to SET VALUE. The Low Battery Alarm Value dialog box will
appear. Input a voltage value between 7 and 18 volts. Use the
↑ ↓ keys
to enter the first number in the dialog box, then press
MENU DOWN to
move to the next digit. Repeat those steps until the desired value has
been entered in the dialog box. To move the cursor back to any of the
previously entered numbers, press
MENU UP. Press PWR to return to
the Battery Alarm menu. Use ↑ to select
ON, which will turn on the
alarm, then press
PWR to clear the menu. If the voltage value falls be-
low the alarm’s setting, the alarm will sound and a message will ap-
pear on the screen. Press
PWR to silence the alarm.
Noise Rejection and ASP
The ASP (Advanced Signal Processing) feature is a noise rejection
system built into the sonar unit. It constantly evaluates the effects of
boat speed, water conditions and electrical interference and automati-
cally gives you the best display possible under most conditions.
ASP is an effective tool in combating noise. In sonar terms, noise is any
undesired signal. It is caused by electrical and mechanical sources such
as bilge pumps, engine ignition systems, wiring, air bubbles passing
over the face of the transducer and even vibration from the engine. In
all cases, noise can produce unwanted marks on the display.
Noise Rejection menu.
The ASP noise rejection feature is especially useful because, typically,
it lets you operate the boat at all speeds without adjusting the sensi-
tivity or other controls.
The ASP feature has three settings — Off, Low and High. When first
turned on, noise rejection is set on low. If you have high noise levels,
try using the high ASP setting. If, however, you are having trouble
with noise, we suggest you take steps to find the interference source
and fix it, rather than continually using the unit with the high ASP