Filter
Top Products
2
IN-DASH MOUNTING
The LMS-350A can be installed in the dash with the supplied hardware if
the dash is 1/2" thick or less. Determining the dash thickness can be
difficult, however, if you remove a gauge from the dash, you can easilly
measure the thickness. Try this in an area that's close to the location that
you wish to install the unit, since the thickness can vary significantly in
some boats. Make certain there is clearance behind the dash for the unit
and there is enough room to tighten the bolts on both sides of the unit.
7.625"
5.375"
DASH CUTOUT
.400" radius
(4 places)
RUBBER PAD
BOLT
CAM CLAMP
(TURNED DOWN)
CAM CLAMP
(TURNED UP)
BOLT
Once you've determined the location for the unit, cut the hole according
to the drawing shown above. Measure carefully before cutting! After
cutting the dash, place the gasket supplied with the LMS-350A around the
unit and place the unit in the hole.
Supplied with the LMS-350A are rubber pads, bolts, washers, and cam
clamps to attach the LMS-350A to the dash. Peel the adhesive backing off
the rubber pads and place one on each side of the LMS-350A in the
location where the cam clamp will touch the back side of the dash. Using
the hardware supplied with the unit, attach the LMS-350A to the dash.
Make certain that the cam clamp on the left side of the unit is pointing down
and the cam clamp on the right side of the unit is pointing up before you
start tightening the bolts.
RUBBER PAD
LOWRANCE