Filter
Top Products
7
Pole Mount
First, thread the pole mounting adapter onto the mounting pole or
ratchet base. Align the pole mounting adapter so the module will face
the bow of the boat. Install and tighten the set screw into the pole
mounting adapter and tighten it securely. This should prevent the GPS
module from unscrewing from the pole. Place the gasket onto the pole
mounting adapter. Now attach the cable to the GPS module and pass
the cable through the gasket, pole mounting adapter, and pole. Set the
GPS module on top of the pole mounting adapter and align the four
threaded holes in the module with the holes in the pole mounting
adapter. Using the four stainless steel 5 mm screws and lock washers
supplied with the LMS-350A, attach the pole mounting adapter to the
GPS module. This completes the assembly.
GPS MODULE
SET
SCREW
POLE
MOUNTING
ADAPTER
POLE
GPS MODULE
CABLE
MOUNTING
ADAPTER
POLE
POLE
CABLE
MOUNTING
ADAPTER
If the pole or mast you're using isn't hollow or if the hole in the middle of
the pole is too small for the connectors, use the cable mounting adapter
supplied with your unit. Thread the cable mounting adapter into the
GPS pole mounting adapter. Then thread the pole into the cable mount-
ing adapter. Route the cable down the outside of the pole.