Filter
Top Products
5
To add an MMC or SD Card
1. Open the card compartment door.
2. Grasp the bottom of the MMC and push the top of the card into the
slot. Once the card is started, press down in the center of the card with
the ball of your finger or thumb and push the card all the way to the
left, until it is firmly seated in the slot.
3. Close the compartment door and fasten the thumb screw finger tight.
Com Port Wiring
The Com-2 communications port wiring diagram below was omitted
from the LCX manual (page 33) and the GlobalMap manual (page 16).
Com-1 can send or receive NMEA 0183 data; Com-2 can only send
NMEA 0183 data.
Com-2 wiring to transmit NMEA position information
to another NMEA-compatible device.
In-Dash and Bracket Installation
The in-dash mounting dimension drawing on page 38 of the LCX man-
ual is only for the LCX-25 and LCX-26. No dash mount kit is available
for the LCX-110 and LCX-111.
In the LCX manual, the drawing on page 37 for an LCX-25 or LCX-26 is
incorrect. A similar drawing for the LCX-110 and LCX-111 was omit-
ted. Both corrected drawings are shown on the following page.
Cable Connections
Following the mounted dimension drawings are illustrations showing
cable connections for the two case types in the LCX series. They correct
page 34 in the LCX manual.
Shield (Ground)
Ground
Com-2
To unit
Blue (Transmit)
NMEA Receive
To Other
Device