Filter
Top Products
4
Here is the proper procedure for navigating a trail or route:
1. From the My Trails or Route Planning menu, press ↓ to the Saved
Trails or Saved Routes list.
To navigate a Trail:
2. Use ↑ ↓ to select a trail, then press
ENT|→ ↓ to NAVIGATE|ENT. Press
↓ to
NAVIGATE and press ENT.
3. Upon arrival at your destination, cancel navigation by pressing
MENU|MENU|↓ to CANCEL NAVIGATION|ENT.
To navigate a Route:
2. Use ↑ ↓ to select a route, then press
ENT| ↓ to NAVIGATE|ENT.
3. Upon arrival at your destination, cancel navigation by pressing
MENU|MENU|↓ to CANCEL NAVIGATION|ENT.
Installation
MMC or SD Memory Card Installation for LCX-110 & LCX-111
In the LCX-110 and LCX-111, the two MMC slots are located in com-
partments on the front of the case. The water-proof compartment doors
are located at the lower right corner. The following figure shows a
close-up of one compartment with the door opened.
Memory card compartment with a 16 MB MMC card installed.
To remove an MMC or SD Card
1. Open the card compartment door by unscrewing the thumb screw.
The screw should only be finger tight. If it was over-tightened, use a
thumbnail, a coin or a screwdriver to open the door.
2. Use the ball of your finger or thumb and press down in the center of
the card, then drag the MMC from the slot. Or, use a thumbnail or fin-
gernail to grab the groove in the bottom of the MMC and drag it out.
See the figure above for the groove location.
Insert card face up,
this way
Thumb
screw
MMC groove for card removal